The Warne® HyperLite™ 1 inch Medium scope rings are the ultimate lightweight optic mounting solution. Crafted from our exclusive MagnaFusion™ Alloy, these rings offer a staggering 35% weight reduction over traditional aluminum scope rings without compromising on strength or stability while providing an unbeatable foundation for your optic.

1 inch Medium rings weigh 2.58 ounces per pair
35% lighter than standard aluminum rings
Integrated recoil lug and dual-screw clamps maintain zero even under the harshest recoil
Precision CNC machined and topped with Cerakote® to ensure flawless performance in any environment
STANAG 4694 interface allows for better return to zero and rigidity
Fits both picatinny & weaver style bases, works best with full width cross slot mounts
Available for 1”, 30mm, and 34mm tube sizes; in Low, Medium, & High
Personalize you rifle with our Special Edition Gray Clamps for a unique contrast
Designed and manufactured in the USA

SPECIFICATIONS

Part Number: 8501M
Fits Objective Size: 44mm
Height: Medium
Dimension A: 1 inch
Dimension B: 0.400 inch
Dimension C: 0.730 inch
Dimension D: .900 inch
Finish Color: Matte Black
Weight: 2.58 oz
Material: MagnaFusion
Fits Objective Up To: 44mm
Scope Tube Diameter: 1 inch
Fits: Maxima/Weaver Bases and Picatinny Rails

INSTALLATION INSTRUCTIONS

Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.

Remove all 4 cap screws and cap on each ring.
Loosen both clamp screws on each ring and place in desired position on Maxima®/Weaver style bases or picatinny rail.
Push each ring towards muzzle to seat recoil keys and tighten clamp screws to 25 in-lb.
Place scope in rings and reinstall cap screws, leave loose.
With the scope still loose in the rings, adjust the scope for eye relief and correct orientation of the reticle.
*Torque Spec are for dry threads, DO NOT USE THREAD-LOCKER COMPOUND
**Many scope manufacturers’ have established specific torque ratings for their scope and you must follow their recommended torque.

To remove the scope, simply loosen the clamp scews on each ring and lift the scope off the mount, tilting slightly to the opposite side of the clamps. To re-mount the scope, simply place the rings into the slots the scope was originally mounted in, slide the rings and scope forward until the recoil lugs contact the front of the slot, and tighten the clamp screws.

IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.

If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.

8501M Warne HyperLite 1 inch, Medium Matte Rings

Q & A